Security Alarms
Categories
- Conventional fire alarm systems
- Wireless Fire Alarm System
- LPCB addressable fire alarm
- Addressable fire alarm system
- Gas detection alarm system
- Electrical Fire Monitoring
- Fire Alarm Fire Extinguishing
- Commercial Burglar Alarm System
- Security Service Equipment
- Commercial security solutions
- Industry Security Equipment
Languages
Important Links
Featured [more]
Fire fighting gas extinguish alarm panel 4 zone
Save: 18% off
Fire Monitor connection system
Conventional Fire Alarm System Maintenance panel Switch
Maintain fire alarm system regularly easy with maintence panel for switch. This MAINTENANCE panel is a key switch, which disconnects actuation circuits in the system to prevent accidental discharge during maintenance operations. Two “LEDS” indicate “SYSTEM ARMED” and “SYSTEM INACTIVE”. When the key is inserted and turned towards “SYSTEM INACTIVE”, the red LED illuminates and the green LED indicating “SYSTEM ARMED” turns off. The key can only be removed in the “SYSTEM ARMED” position. This panel is also available with the key removable in both the “ARMED” and the “INACTIVE” positions. The information is silk-screened on a two-gang stainless plate. Switch rated at 5A 250VAC, the DC rating is 5A up to 30VDC. LEDs rated at 10mA each for a total current draw of 20mA.
$30.00
Deflation indicator Gas release lamp
Gas release lamp Deflation indicator FQ119 technical parameter 1. working voltage: DC24 + 15% (no polarity) 2. rated current: less than 60mA 3. ambient temperature: -10 C +55 C 4. relative humidity: less than 95%. 5. flash strength: more than 1.2WS 6. the number of light: = 120 times / min 7. life is more than 30000 times: strobe flash 8. product size: 300*120*26mm Contact us if you have any inquiry of fire alarm and fire automatic fighting.
$25.00
Addressable Zone Monitor Unit Fire Alarm System I/O module
TX7201 Addressable Zone Monitor unit is an addressable interface module, which will integrate conventional detectors or conventional manual call points to addressable system. When any of the connected devices alarms are active, the unit can send the alarm message to fire alarm controller, which generates alarm signal and displays its address. The unit can match with the conventional optical smoke detector, conventional rate of rise and fixed temperature detector and conventional manual call point etc. It has the function of checking short or open circuit of the output connection, by the End of Line Resistor (EOLR). The fault massage includes open circuit, short circuit or any removal of the detectors.
Handheld Programmer Fire Alarm System setting tool TX7930
The fire alarm system programmer is used for TX brand addressable fire alarm control panel. With the programmer, the smoke detector, heat detector, gas sensor, manual fire alarm button, manual call point and input output module can be encoded with address. After all fire detectors are encoded, it can be installed on ceiling, wall of protected areas and warning areas. Each detector has unique address and when alarm occurs, from the displayer and alarm panel, the alarm point will be known immediately. You can easy program detectors with fire alarm system programmer.
Isolator Module Addressable Fire Alarm System TX7230 LPCB Cert.
The TX7230 manufactured base on the requirement of EN 54 part 17, European Standard. In the event of short circuit on the detection loop the TX7230 Isolators either side of the loop will detect the problem and open circuit and isolates the faulty part of the loop, enabling other devises on the unaffected part of the loop to operate normally. The module will continue to monitor for the fault to be repaired, once the fault is cleared the isolator will automatically reinstate the effected part of the loop.
More Information
BOX_HEADING_TWITTER_SIDEBOX
Specials [more]
Fire fighting gas extinguish alarm panel 4 zone
Save: 18% off
Conventional Beam Detector non-addressable infrared smoke sensor
Save: 33% off
